中美洲自由貿易協定產品網

H beam Assembling Machine

Key Features
Specification

A. Main Specification:
The Hydraulic H-Beam Assembling Equipment which the flange plate, web plate, fastening and calibrating, positioning, and auto spot welding equipped.

B. Workability for Assembling
Width of flange: 125MM – 600MM
Height of Web: 300MM-1500MM
Thickness of flange: 6MM – 25MM
Thickness of web: 6MM – 45MM
Operation speed: 1 – 7 m/min

C. Machine specification
Electric rating power source AC 380V/50/60hz
power consumption 9.3kw
Max. current 38A
Hydraulic Cylinder Diameter 80 MM ,Stroke 1200MM
Hydraulic Pump-5 HP Motor-Pressure 7l/min.160kg/cm2
Rated Pressure 30 ~ 50kg/cm²
Driving motor MP305L3 7.5 HP/4p inverter motor

D. MACHINE:
1. The device for edge position: can measure the edge of flange and web before assembling.
2. Flange guide roller: For assembling, this is set on the front roll table to guide smoothly the flange plate unto the machine in right position by meter, which can measure the position of the guide roller.
3. The digital readout displays for flange (front/rear) position: can easy to read the position of flange (front/rear), by the screw motor and encorder.
4. Web pressing side roller: These are set on the inner side of the column to keep the web plate from warping.
5. The digital readout displays for web (front/rear) position: can easy to read the position of web (front/rear) by the screw motor and encorder.
6. Automatic Track co2 welding Device: for co2 spot welding, welding length be varied at discretion
7. Driving roller: drive lower roll and upper roll can hold the flange plate and the web plate.
8. The digital readout displays for travel speed: can easy to read and adjustment the speed.
9. Upper roll: can move and press the web to the flange by hydraulic system

E. Optional Equipment
1. WELDING EQUIPMENT
a. Lincoln CV-655 Power Source………...…2SETS
b. Lincoln wire feeder F-72…..………………2SETS
c. CO2 torch ...…………………...……………2SETS
2. Front and rear conveyor and turn over machine

886-3-3502467

886-3-3506730